Airflow dryer copper sulfate 1000kg/h

The heater uses steam heating, with a steam pressure of 0.6 MPa.

Structure type: 304 tube with aluminum fins, shell 304.

Drying temperature:

Equipment Name Drying Temperature

Copper sulfate dryer 70±5°C

An air filter should be installed before the dryer's air intake, with the material being 304 stainless steel and non-woven fabric. The filter area and air intake volume should be designed by the manufacturer based on the processing capacity.

The drying pipe section should be made of titanium material, with a wall thickness of ≥4mm.

The material of the discharge bin should be TA2, with a capacity of no less than 0.5 m³. The discharge port should be located no higher than 1.50 m above the ground to ensure ease of operation for personnel.

An air hammer should be installed at the discharge port at the bottom of the discharge bin for vibration.

The material of the dust collector should be 316L, and the filter bag material should be coated with a membrane, with no visible dust.

The dust collector filter bags should be equipped with pneumatic pulse to prevent clogging.

The discharge port of the dust collector should be equipped with an air hammer for rapping, and the exhaust port should be fitted with a dust suction device to prevent dust dispersion.

The exhaust fan should be made of steel-lined fiberglass, be heat-resistant, and be equipped with a fiberglass protective cover.

The exhaust pipe is made of fiberglass.

The exhaust air temperature is 65°C.

The dryer system should be equipped with a thermometer and a pressure gauge for on-site display.

The inner and outer surfaces of the equipment should be polished, with no scratches on the surface and no dead corners.

The insulation layer shall be no less than 50mm, and the density of the insulation material shall be no less than 125 kg/m³.

Stainless steel protective plate: 304, Thickness: 0.3mm.